The 1972 Datsun 240Z was bought out of New Mexico. It is a running and driving car but has been off the road for a while. I bought it as a project but my situation has changed and I've decided to sell it. I was told the engine has about 5k miles on an overhaul but I have no proof. It has a Clifford intake manifold and an Edelbrock 1406 carb. The carb needs overhauled but will start and run fair. It comes with the stock intake/carbs/air cleaner as shown in the hatch area pics. It has a new clutch slave cylinder that needs bled to work properly. The pictures show the worst areas on the body and the whole cut in the passenger side floor was there when I bought it. I'm guessing there was rust there. The remaining floor seems solid. There is bondo on the rear driver side quarter and a crack that can be seen in the pics. The passenger side seems solid but there is cracking above the body line on that side. It looks like there is filler in that area and over the door area on the roof on that side. The inner hatch and spare tire area are solid. The firewall is solid and below the battery tray area. The missing items are the center console, the two front turn signal assemblies, the blower motor, the wiper motor and linkage, carpet, and door panels. The seats are usable and the door panels are there but trashed. If you want pics of anything specific, I'll get them for you. Shipping is at the buyer's expense and the buyer will have to set this up themselves.
