- Z-Series (2)
Datsun cars for sale in Pearland, Texas
1-2 of 2
Sort By
Datsun : Z-Series 280Z Datsun 280z ready for swap
$4,800
Pearland, Texas
Shell is great for someone with a rusted body looking to transfer as it is very clean. Currently in primer. It will need a nes hood or to have current hood fixed as it has a few rust spots, not unfixable though. Car was setup for v8 swap and has fuel cell installed, coilovers on all 4 corners, shaved engine bay ( battery tray removed). I have the interior for the car I am missing one a pillar trim piece. Dash work was started for removing the side ac vents since roll cage and vintage air was going into the car. This isn't a 2k z so don't ask. If its your first z you won't understand the cost of Zs and why the body is so important as you will almost always pay more to bring the body back to life than the car itself. Rear spoiler is shown in pictures but not included with car. Car has 2 spots left that need to be addressed. I was just going to grind that out and prep with por15 as that is covered by door seal. No need to waste 100 getting that cut and replaced. Underneath the car is nice and clean (dusty as its in storage) Video: Underneath. https://youtu.be/ZlAWtCVXYCo Walk around. https://youtu.be/YKHwfF0BaM4 Feel free to call or text 2817047534 Kevin
Trim 280Z
Datsun : Z-Series 280Z Datsun 280z ready for VQ35HR swap motor trans and wiring TRADE ?
$7,500
Pearland, Texas
Selling \ trading my project to do something bigger. Car has had extensive body work done to it. Fuel cell in place, coil overs on all 4 corners, big brake upgrade for front desk, complete original interior, new bushings everywhere. Car will need a new hood prior to paint. Also comes with front air dam new in box from MSA. Work was started on dash to cover the side vents so that vintage air unit would blow from center only. Vintage air unit not part of the listing. The VQ motor is out of a 2007 NISMO 350z that had 22k miles. I personally drove the car and verified the miles prior to pulling. I pulled the motor as well and the harness is complete, the only wire that was cut goes to the brake controller. Also have the drive by wire gas pedal and the ignition with original key. Transmission is still connected to motor. All accessories are also still on the motor. McKinney motor sports sells the items needed for the swap (Drive shaft, engine mount, trans mount and shifter relocating bracket) for 1800. I kept the wiring harness complete so that I could use the existing NATS on the car. I would prefer a project I will be able to enjoy with both of my kids when wife's not around. Will consider trades 2 doors with 4/5 seats, No 4 door, nothing past 1986 and no rust buckets. Rolling chassis are welcomed if its the right one 55/56/57 no post rollers, nomad, hudson hornet, pontiac safari wagon and so on are welcome. I like classics a lot. I've done a lot of Zs and this was going to be my favorite one of all, but have to be practical at some point. I still have the donor car I pulled the motor from so if there is any other part you think you may need off of the car feel free to let me know. Shipping will require a shipper who will crate the motor and trans for you. Calls are welcomed 281-704-7534 Kevin
Trim 280Z
