1965 fastback project car,no motor or trans original 6-cyl stick car . Front frame rails are solid Rear frame needs a patch on the passenger side about 2" Rockers are solid Rear quarters will need the lower portions patched Drivers side door is junk, passenger side may be usable Front, and rear glass are in good condition. Comes with the rear fastback interior flap comes with 2 front fenders, and headlight buckets. Fastback roof is solid. Floor pan needs patching, i have welded in a new passenger side pan, i will include the full drivers side pan as well. i have added the passenger side torque box, and i will include the driver side. V8 suspension will need the inner and outer tie rods replaced. V8 hubs, spindles "hood not included" includes rear trunk lid assume nothing else is included, i may add parts to go with the car. The car has a solid project car that needs work to make it a keeper. I am finishing my masters so i dont have a lot of time to work on the car. thanks Car is Sold AS Is.
Here is a 1965 Mustang Fastback A-Code 3 speed manual. Car needs work, but the frame rails look solid, and the engine looks to have many performance parts. i removed the valve covers, and found crane rockers, and i can also see the engine has a performance carb, and long tube headers. the engine bay looks to have little to no rust. the previous owner had sand blasted the trunk area, but never put primer so the back end has surface rust. otherwise this car looks solid, and has the front disk calipers. mustang currently has a automatic transmission, but the clutch pedals are still there. Clean tittle no low ball offers. Sold as is needs: floor pan patches. "included" driver side quarter panel. "not included" passenger side door "not included" also includes: driver side seat. trunk missing the interior. rally pac is not included "sent it off to be refurbished, and they lost it. :(
