Nissan cars for sale in Millbury, Massachusetts

Nissan : 200SX SE-R Coupe 2-Door 1997 nissan 200 sx se r coupe 2 door 2.0 l built sr 20 de

$5,000

Millbury, Massachusetts

I am selling my 97 Nissan 200sx SE-R. This a very fun and capable car I have roughly 15,000.00 in performance modifications done. The engine was built with the intent on turboing the car but never got around to installing the turbo. The car runs and drives dependably but I'm affaid I have to sell, I enlisted in the U.S. Army and couldnt take the car with me. The cylinder head was disassembled, cleaned, inspected, and reassembled with the following components: -competition 3 angle valve job with 0.040" valve seats -Valve job performed on a Serdi machine -cylinder head ported and flow tested on a SuperFlow 600 flow bench using Audie Technology digital interface -exhaust valve guides replaced with manganese bronze and honed to spec -all 16 valves reground using Kwikway valve grinding machine -cylinder head deck milled to ensure flatness(0.010" deckmill) -valve shims ground to fit Tomei solid lifters -fwd sr20de valve cover powder-coated black with breather baffles removed and rear breather tube plugged off -HKS adjustable camshaft gears -Greddy rocker arm stoppers -Tomei solid lifter -Peak Performance race spec valve springs -oem valve stem seals -HKS 272 step 3 intake camshaft(228 degrees at 0.050" lift, 12.6mm lift) -Nismo 280 exhaust camshaft(224 degrees at 0.050" lift, 12.6mm lift), this is an extremely rare camshaft. it was briefly made and I had to buy it directly from a distributor in Japan. -FWD Cometic 0.040" MLS head gasket -Nissan Pulsar GTI-R individual throttle bodies -Cutsom made intake plenum -Profab insulating intake manifold spacer gasket - Nissan Pulsar GTI-R 444cc injectors -IAT Sensor -Wired up for map sensor (planned to boost it the spring) -AEM Series 2 stand alone ecu -Greddy Front&Rear sway bars -Tokiko Blue struts -TIEN lowering springs -Full custom 3'' exhaust (done by Lou's Custom Exhaust) -Custom intake manifold (done by T&M Performance) -Custom cold air intake (done by Lou's Custom Exhaust) There are a lot more modifications but this list is just off the top of my head I also have a rwd race plenum for the individual throttle boddies. I had a 240sx that this build was going to go into but I went a different route. Now the cons: -Rust on the rear quarter needs some attention -I put a new factory front end on the car which is primed black the car needs to be painted. -Needs a battery I'm asking 5000.00 no low ball offers there is a lot of time and money into this car serious inquiries only

Trim SE R Coupe 2 Door